Window Tint Film Installation Instruction
Please visit our YouTube channel for helpful videos on how to tint windows at www.YouTube.com/LexenAuto
Tools:
Squeegee, knife, johnson baby shampoo or dish soap, spray bottle, and paper towel as well as a heat gun if needed
Professional tint tools kit can be found at our online store at www.LexenAuto.com
Preparation:
Create your own wetting solution (soapy water) by adding a few drops of Johnson baby shampoo or dish soap into a spray bottle filled with water
Start with a clean car, and a relatively dust and wind free environment
The tint is applied on the inside of the windows. You may work the window film on the outside, but the window film is installed on the inside
(Please visit our YouTube channel for videos regarding this)
Precautions:
The surface to which the film will be applied should be very clean, free of dirt and dust particles. Make sure there are no dry spots on the film prior to placing it onto the glass
Take care that when removing the release liner, the film does not roll over onto itself. Once stuck together, it’s difficult to pull apart. Wet the film as the liner is removed
Tip to remove liner:
To separate the liner from the film, take two pieces of scotch tape and stick them opposite each other at one corner, then pull these two pieces of tape apart, the liner will separate from the film
Remember: Your new film takes 1-3 weeks to fully cure. You may see some haze or condensation during this period. Please allow film to cure 2-3 days before lowering windows
Please leave us a positive feedback. We stand behind our product 100%
Contact us by Amazon/eBay message or sales@lexenauto.com if you have any issues